We take a bottom-line approach to each project. Our clients consistently see increased traffic, enhanced brand loyalty and new leads thanks to our work.
By installing a roller from the inside of the window glass, it prevents direct sunlight from entering in the summer and at the same time prevents indoor heat from escaping from the window in the winter. Air conditioning costs can be reduced by 25-30% by reducing the air conditioning load. A thermal barrier glass coat that cuts both infrared and ultraviolet rays.
In the summer, when the solar heat hits the window glass, about 60% of the solar heat is absorbed by the window glass coated with IRUV cut coat, and nearly 40% of the heat absorbed by 60% of the heat is re-radiated to the outside. It shields direct solar heat from 5 ℃ to 15 ℃. The temperature goes down 2 to 3 ° C throughout the room.
Regarding infrared, the wavelength range of the direct heat of the hot summer sun is said to be near infrared. Heatcure has a near infrared cut rate of 90%. Most other glass coats have a near-infrared cut of 50% or less. Please note that the cut rate of 90% or more of far-infrared rays that hits the heating heat in winter is described as infrared rays, and that it may be misleadingly explained as if it has high heat-shielding properties in summer. The Heatcure will not let the heat of the winter heat escape from the window.
The HEATCURE -IRUV cut coat has a UV cut rate of over 99%. As a result, the following effects can be expected. ・ Prevents UV degradation of flooring. Prevent fading of display products such as clothes and bags, ・ Prevents spots and freckles that are UV damage to skin
Condensation cannot be stopped, but it can be suppressed by 50% or more. Condensation occurs and turns white, but water drops are extremely reduced. There are fewer chill zones in the window.
The direct solar heat enters the room most in the morning on the east, noon on the west, and Soth in the evening, but the coated surface is shielded from 5℃ to 15℃ against the uncoated surface. There is not much difference on the surface where direct sunlight does not enter. From 10am to 16pm, where the air conditioner is most loaded, the higher the temperature, the greater the heat shield width. There are a lot of temperature measurement data so far, and the temperature difference data can be confirmed in the data.
The colour tint is almost transparent. The visible light transmittance (transparency) is almost 10-15% lower than before coating. Visible light transmittance of automobile windshield is about 70%, but this coating material is about 75% more transparent than car windshield and looks almost transparent.
It has a durability of 15 years or more after one application. (In the case of indoor coating application.) When the UV cut rate is over 15 years, little by little deteriorated and the acrylic resin turns white gradually, so it will be peeled off by remover and re-application can be done.
There are 4 types of film. One is a crime prevention film, which is a thick type of 200 to 350 microns. The second is an anti-scattering film with UV cut. The third is a coloured sunshine adjustment film with UV cut. The fourth is a transparent thermal barrier film and an anti-scattering film. Of these, the fourth transparent thermal barrier film is a competitive product. First, the UV cut rate of the film is 99%, which is almost the same as HEATCURE coating. Other than that, HEATCURE IR coating has the following advantages. • The application price is low. • The durability is more than doubled and the weather resistance test is over 10 years. • Film is durable for 5-7 years • Easy to install and easy to peel off. • There are no joints like film. • There is no nighttime reflection. • Thermal cracking is less likely than film.
After installation, the surface of the coating is dried (30 minutes in summer, 1 hour in winter), the Odor disappears in 2 to 3 hours with the window fully open. If the window cannot be opened or closed, it may remain until the next day. For this reason, if you are worried about the Odor after application, deodorize with negative ion or ozone generator. Since it is solvent-based, there is a smell of nail polish remover. The Odor disappears over time. However, for several hours after the application until the surface is dried, ventilation is not possible, so the smell fills the room in the case of small narrow space.
It is a problem if you drink the paint liquid as it is, but there is no problem if it’s licked after it dries. That kind of problem has never happened so far, please look at the product safety data. Ingredients do not include 14 items of TVOC. There is no elution of formaldehyde, acetaldehyde, toluene, xylene, benzene, etc. after application.
There are many variations of passages of available but the Ut elit tellus luctus nec ullamcorper at mattis
The hardness of the pencil hardness test is 4H. So, if it is a level that does not damage the glass, it will not be damaged.
Complete curing takes half a month in summer and one month in winter, so be sure to clean it after one month. Also, because it is only vulnerable to caustic soda (alkaline), clean the window with water or neutral detergent only. Please note that if there are any problems with cleaning with other ingredients, the application is not covered by the warranty.
An application is guaranteed free of charge if yellowing, cloudiness, or peeling occurs within 10 years, not by the customer's negligence. However, an application on the film are not covered by the compensation.
Finger contact drying from 30 to 60 minutes, is safe to touch after 3 hours.
Although it can be installed outside, for example, it may not be possible on a rainy day, or it may be expensive to install a scaffold for a high glassy window. In addition, even if it is applied, it cannot be guaranteed due to the problem of acid rain, so if you give priority to price, durability or warranty, we recommend an interior window application.